Safety instructions

To prevent possible electric shock, fire or personal injury, and to ensure safe operation of this product:

• Please read all safety instructions before using the product.
• Read all instructions carefully.
• Do not modify the product and use the product only for the specified purpose, as this may reduce the protection provided by the product.
• Replace the batteries when a low battery indication is displayed to prevent incorrect measurements.
• Do not use the product if it is working abnormally.
• Do not use the product if it has been altered or damaged.
• If the product is damaged, disable it.
• For actual temperatures, see Emissivity information. Reflective objects can cause the measured temperature to be lower than the actual temperature. These objects can create a burn hazard.
• Do not place the battery and battery pack near sources of heat or fire. Do not expose to sunlight.
• Do not disassemble or squeeze the battery and battery pack.
• If the product is not used for a long period of time, remove the batteries to prevent them from leaking and damaging the product.
• Keep the battery and battery pack clean and dry. Clean the connectors with a dry, clean cloth.
• Batteries contain hazardous chemicals that may cause burns or explosions. If exposed to chemicals, clean with water or seek medical attention. Do not disassemble the battery.
• If a battery leak occurs, repair the product before use.
• Do not put metal objects into the connector.
• Have the product repaired by an approved technician.
• If the rechargeable battery becomes hot (>50 °C) while charging, disconnect the battery charger and move the product or battery to a cool, non-flammable location.
• To avoid electric shock, always disconnect the meter pen before removing the battery, connecting the USB, charging, removing the case, etc.

The symbols used on the thermal imaging camera or in this manual are listed in Table 1.

The next page is the technical characteristics