Safety instructions

To prevent possible electric shock, fire or personal injury, and to ensure safe operation of this product:

• Please read all safety instructions before using the product.
• Do not modify this product and use it only for the intended purpose, as this may reduce the protection provided by the product.
• Replace the batteries when a low battery indication is displayed to prevent incorrect measurements.
• Do not use the product if it is working abnormally.
• Do not use if the product has been altered or has been damaged.
• For actual temperatures, see Emissivity information. Reflective objects can cause the measured temperature to be lower than the actual temperature. These objects can create a burn hazard.
• Do not place the battery and battery pack near sources of heat or fire. Do not expose to sunlight.
• Do not disassemble or squeeze the battery and battery pack. Batteries contain hazardous chemicals that may cause burns or explosions. If you come in contact with chemicals, clean with water or seek medical attention.
• If the product is not used for a long period of time, remove the batteries to prevent damage to the product from battery leakage.
• Keep the battery and battery pack clean and dry. Clean the connectors with a dry, clean cloth.
• If a battery leak occurs, repair the product before use.
• If the rechargeable battery becomes hot (>50 °C) while charging, disconnect the battery charger and move the product or battery to a cool, non-flammable location.
• Do not put metal objects into the connector.
• Have the product serviced by an approved technician.
• To avoid electric shock, always disconnect the meter pen before removing the battery, connecting USB, charging, removing the case, etc.
  The symbols used on the thermal imaging camera or in this manual are listed in Table 1.

Table 1 lists the symbols used in the thermal imager or in this manual.

Next page technical features